GLUC. OX. Conjugation Kit

GLUC. OX. Conjugation Kit gallery image 1

Purchased this product? Why not be the first to submit a review and upload an image?

  • GLUC. OX. Conjugation Kit thumbnail image 1
  • LYNX Rapid Glucose Oxidase Antibody Conjugation Kit
(Rated 0.0 out of 5 based on 0 customer reviews)
  • Product Type
    Conjugation Kit
1 Formats Available
    Product CodeApplicationsDatasheetMSDSPack SizeList PriceQuantity
    LNK051GOXCJdatasheet pdfdatasheet pdf datasheet pdf datasheet pdf3 Conjugations For 100µg Antibody
    Secondary Antibodies
    Negative Isotype Controls
    Useful Reagents
    Positive Controls
    Histology Controls
    More Images
    • Lynx Rapid Glucose Oxidase Antibody Conjugation Kit® enables the rapid conjugation of a pre-prepared lyophilized mixture containing glucose oxidase (GOx) label to an antibody or protein. Activation of proprietary reagents within the antibody-label solution results in directional covalent bonding of GOx to the antibody.

      The LYNX Rapid Conjugation kit® can be used to label small quantities of antibody/protein at near neutral pH, allowing a high conjugation efficiency with 100% antibody recovery.
    • Intended Use
    • Product Form
    • Reconstitution
    • Preparation
    • Preservative Stabilisers
    • Purity
    • Approx. Protein Concentrations
    • Reagents In The Kit
      3 Vials of 100ug LYNX lyophilized GOx mix (source Aspergillus niger)
      1 Vial LYNX Modifier reagent
      1 Vial LYNX Quencher reagent
    • Preparing The Antibody
      The following buffer solutions are recommended for preparing the antibody:

      10-50mM amine-free buffer (e.g HEPES, MES, MOPS and phosphate) pH range 6.5-8.5, although moderate concentrations of Tris buffer (<20mM) may be tolerated.

      If possible, avoid buffers containing nucleophilic components such as primary amines and thiols (e.g. thiomersal/thimerosal) since they may react with LYNX chemicals. Azide (0.02-0.1%), EDTA, up to 50% Glycerol and common non-buffering salts and sugars have little or no effect on conjugation efficiency.

      It is recommended that 100ug of antibody be used for every 100ug GOx, corresponding to a 1:1 antibody: GOx molar ratio. For optimal results the antibody should be at a concentration of 1mg/ml, with a maximum volume of 100ul and a maximum antibody amount of 100ug. Antibody at a concentration of greater than 1mg/ml requires dilution. Antibody below 1mg/ml can still be used as long as the maximum volume is not exceeded. Using less than the recommended amount of antibody may result in unbound label, but this will be removed during subsequent application wash steps. Antibody below 0.5mg/ml should be concentrated before use with the kit.
    • Test Principle
    • Buffer Solution
    • Storage
      Store kit at -20oC only.
      Newly-conjugated antibody can be stored at 4oC. For long term storage however, the addition of a preservative is recommended.
      Storage in frost-free freezers is not recommended.
      This product should be stored undiluted.
      Avoid repeated freezing and thawing.
    • Shelf Life
      12 months after despatch
    • Acknowledgements
    • Licensed Use
      These products and the methodology of conjugation are patent protected under United Kingdom patent number 2446088 and associated international patent applications. The purchase of this product conveys to the buyer the limited, non exclusive non-transferable right (without the right to resell repackage or further sublicense) under these patents to use the product to make conjugates for research and development purposes only. The purchaser cannot sell or otherwise transfer this product, or its components, or materials or data made using this product, or its components to a third party. Further information on purchasing licenses for diagnostic and other uses may be obtained by contacting Bio-Rad, at. Endeavour House, Langford Business Park, Langford Lane, Kidlington, Oxon. OX5 1GE UNITED KINGDOM. Tel: +44 1865 852 700. E-mail:
    • Regulatory
      For research purposes only
    • This product has been reported to work in the following applications. This information is derived from testing within our laboratories, peer-reviewed publications or personal communications from the originators. Please refer to references indicated for further information. For general protocol recommendations, please visit the antibody protocols page.

    • Application NameYesNoMin DilutionMax Dilution

    • We recommend that for each conjugation the user determines the best antibody:conjugate ratio.
    • Technical Advice
    • Recommended Protocol
    • ELISA
    • Immunohistology
    • Histology Positive Control Tissue
    • Immunofluorescence
    • Western Blotting
    • Instructions For Use
      1. To the antibody sample add 1ul of the Modifier reagent for every 10ul of antibody and mix gently.

      2. Pipette the mixed antibody-modifier sample directly onto the LYNX lyophilized mix and gently pipette up and down twice to resuspend.

      3. Replace cap onto vial and incubate in the dark at room temperature (20-25oC) for 3 hours, or overnight if preferred.

      4. After incubation, add 1ul of Quencher reagent for every 10ul of antibody used. Leave to stand for 30 minutes before use.

    Additional GLUC. OX. Conjugation Kit Formats

    Formats Applications Sizes available
    GLUC. OX. Conjugation Kit : Kit CJ 3 Conjugations For 100µg Antibody
    • Copyright © 2017 Bio-Rad Antibodies (formerly AbD Serotec)

    Recommended Secondary Antibody

      Recommended Negative Isotype Control

        Useful Reagents

          Recommended Positive Controls

            Histology Controls

              Write your review

              You may also be interested in...